OUTPUT MODULE 4 SOLID STATE 24V
Inline power terminal block, complete with accessories (connector and labeling field), without fuse, 120 V AC
Motherboard, for accommodating 16 PI/Ex- process interface modules, for assembly on NS 35/7.5 or NS 32
Pg screw connection, plastic, (IP67), for INTERBUS and PROFINET motor starters and variable frequency drives.
Insertion bridges, divisible, isolated comb spine, color blue, 84-pos.
DIN rail housing, Upper housing part for connectors with header, width: 45.2 mm, height: 99 mm, depth: 45.85 mm, color: light gray (7035)
Ex i motherboard to accept 16 x PI-Ex i NAMUR repeater power supplies (PI-EX-NAM), FLK pin strips for connection to S7-300 digital in cards using system cables, disconnect plug terminal blocks for the field side, assembly on NS 32, or NS 35/7.5.
DIN rail housing, Lower housing part with metal foot catch, flat design, with vents, width: 22.6 mm, height: 99 mm, depth: 84.8 mm, color: green (6021), cross connection: without bus connector, number of positions cross connector: not relevant
Ex i motherboard to accept 8 x PI-Ex i repeater power supplies, input signal conditioners etc. (PI-EX-), FLK pin strips for connection to S7-300 analog in cards using system cables, disconnect plug terminal blocks for the field side, assembly on NS 32, or NS 35/7.5.
Ex base terminal block for intrinsically safe signals with knife disconnection and test connections
Analog IN-motherboard for S7-300, to hold PI-C-UI-UI-AI, mounting on NS 32, or NS 35/7.5.
Analog out motherboard for S7-300, to hold PI-C-UI-UI-AO, mounting on NS 32, or NS 35/7.5.
Plug-in miniature power relay, with multi-layer gold contact, 2 PDTs, input voltage 48 V DC
Plug-in miniature power relay, with power contact for high continuous currents, 1 PDT, input voltage 48 V DC
Preassembled relay modules PR1-RSC... with screw connection, consisting of: relay base, multi-layer contact relay, pluggable display or interference suppression module and retaining bracket. Input voltage: 120 V AC, 1 PDT, 12 A
Plug-in module, with RC element, input voltage: 120 ... 230 V AC/DC 20 %
Insertion bridges, divisible, isolated comb spine, color red, 84-pos.
Plug-in module, for mounting on PR3, with damping diode and yellow LED, polarity: A1+, A2-, input voltage: 48 ... 60 V DC 20 %
Ex i binary input: NAMUR isolation amplifiers. For operating proximity sensors and switches in Ex areas. The binary signals are transmitted to a safe area. Transistor output (active), line fault detection. Electrical isolation.
Ex basic terminal block, with three terminal points to the field level (Ex area)
Interface module for connecting PoE twisted pair ports, RJ45, connection direction forward
Plug-in miniature power relay, with power contact, 2 PDTs, input voltage 48 V DC
DIN rail mountable Ethernet hub with eight RJ45 ports supports Ethernet with 10 Mbps as well as with 100 Mbps
Plug-in module, with varistor, input voltage: 120 ... 230 V AC/DC 20 %