D-SUB connector, 9-pos., male connector, two cable entries < 35, bus system: Modbus, Modbus Plus, BITBUS, ARCNET, MULT/MININET (B&R), SYSTEM 2003 (B&R), P-NET, pin assignment: 1, 2, 3, 5, 6, 8 to two screw connection terminal blocks
D-SUB connector, 25-pos. female connector, one cable entry < 35, universal type for all systems, pin assignment: 1, 2, 3, ..., 24, 25 to screw connection terminal block
D-SUB connector, 15-pos. female connector, one cable entry < 35, universal type for all systems, pin assignment: 1, 2, 3, ..., 14, 15 to screw connection terminal block
Primary-switched TRIO POWER power supply with push-in connection for DIN rail mounting, input: 1-phase, output: 24 V DC/3 A C2LPS
Interface converter, for the electrical isolation of two RS-232 interfaces, 4 channels, integrated DTE/DCE switch-over, DIN-rail mountable
Primary-switched UNO POWER power supply for DIN rail mounting, input: 1-phase, output: 5 V DC/25 W
Adapter Cable 9/25-Pole D-Sub
RS-232 cable, 9-pos. D-SUB socket 25-pos on D-SUB socket
D-SUB connector, 9-pos. female connector, two cable entries < 35, bus system: CANopen, FIP, pin assignment: 2, 3, 6, 7, 8, 9 to two screw connection terminal blocks
M23 power supply connector, male connector, 6-pos.
M23 solder connection for bus connector set, male/female connector, 9-pos. (8+1)
Termination Boards for Siemens SIMATIC S5 PLCs, with electrical isolation
Rectifier module, with varistor protective circuit, operating voltage 230 V AC
INTERBUS-ST digital output module, 32 outputs, 24 V DC, 500 mA, 2-wire connection method, IP20 protection, consisting of: Terminal part with screw connection and module electronics, extended temperature range
Digital output module, IP20 protection, consisting of terminal part with screw connection and module electronics
The INTERBUS protocol microcontroller IPMS-3 is a CMOS gate array. The IPMS-3 is used with a variety of processors
Passive RS-485 T-distributor, fitted with one 9-pin D-SUB pin strip and two 9-pin D-SUB socket strips
Serial register extension chip for INTERBUS slave protocol chips
Protocol chip, in SOP 16 housing
Slave protocol chip, for INTERBUS (QFP 100)
Bus connector set, crimp connection, male/female connector
Bus connector set, solder connection, male/female connector
User Manual, English, for power supply units
D-SUB connector, 9-pos., male connector, axial version with two cable entries, bus system: PROFIBUS DP up to 12 Mbps, termination resistor can be switched on via slide switch, pin assignment: 3, 5, 6, 8; spring-cage connection terminal blocks